Rockwell Automation DEVICENET 1771-SDN Instrukcja Instalacji

Przeglądaj online lub pobierz Instrukcja Instalacji dla Czytniki kodów kreskowych Rockwell Automation DEVICENET 1771-SDN. Rockwell Automation DEVICENET 1771-SDN Installation manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 15
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
D
D
e
e
v
v
i
i
c
c
e
e
N
N
e
e
t
t
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
G
G
u
u
i
i
d
d
e
e
l
l
i
i
n
n
e
e
s
s
DeviceNet will not function correctly if design rules are not followed.
Even a Network previously thought to be functioning correctly may begin
to exhibit abnormal or anomalous operation due to incorrect system design.
The following are tips to help locate and correct these abnormalities.
For specific DeviceNet system installation information.
Please refer the "DeviceNet Planning and Installation Manual".
Manuals can be ordered via the Internet at http://www.theautomationbookstore.com/
Verify that all devices on the network have been certified by ODVA and
carry the DeviceNet Conformance check on their name plate.
Termination Resistors:
A termination resistor equal to 121 Ohms 1% , 1/4W must be attached at each end of the
Trunk cable. The resistors must be connected across the Blue & White wires of the
DeviceNet cable.
Resistor connection can be verified by disconnecting DeviceNet power and measuring
the resistance across the Can_H & Can_L lines (Blue & White Wire). This can be
measured with an Ohm meter. The reading should be approximately 60 Ohms.
Very Important: The DeviceNet network will not operate correctly without terminating
resistors. Termination resistors can be ordered from your local Allen-Bradley Distributor
using the part number 1485A-C2.
Page 1 of 15
Przeglądanie stron 0
1 2 3 4 5 6 ... 14 15

Podsumowanie treści

Strona 1 - Termination Resistors:

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess DeviceNet will not function correctly if design rules are not followed. Eve

Strona 2 - Power Supply Discussion:

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess DeviceNet Scanner Status / Error Codes The bicolor (GREEN/RED) module stat

Strona 3 - Verify Network Voltages

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess -------------|-----------------------------|--------------------|----------

Strona 4 - Check the Wiring

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess ---------------|-----------------------------------------|-----------------

Strona 5 - Check the Nodes

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess ---------------|-----------------------------------------|-----------------

Strona 6

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess ---------------|-----------------------------------------|-----------------

Strona 7 - Points to Remember

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess Page 15 of 15 80%-90% of all network problems stem from miswiring, loose

Strona 8 - Ground Loops

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess Network Grounding: The DeviceNet cable must by grounded at only one locati

Strona 9

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess Verify Network Voltages It needs to be understood that DeviceNet is actual

Strona 10

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess Examine the System Design of the Installation  Walk the network if possi

Strona 11

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess  Check the Scanner Configuration  Verify the scanlist  Baud Rate 

Strona 12

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess If scanner goes bus off again, The problem is some combination of Defectiv

Strona 13

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess Points to Remember Pressing the reset button on the scanner does not reset

Strona 14

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess Opens or shorts may be the biggest problem. On an idle bus (without traffic

Strona 15 - Product Features

DDeevviicceeNNeett TTrroouubblleesshhoooottiinngg GGuuiiddeelliinneess DeviceNet QD Connectors Examining the connector with the keyway pointing do

Komentarze do niniejszej Instrukcji

Brak uwag