Rockwell-automation 1502 Electrically-Held to Mechanically Latched Con Instrukcja Użytkownika Pobierz pdf (Strona 11)

Electrically Held to Mechanical Latch Contactor • Retrofit Instructions 7

1502-IN001%-EN-P – -XQH 20

Mechanical Latch Mechanism Set-Up

1. Place the contactor on its side.

2. With the contactor still clamped closed, set the gap between the

Latch Roller and the contactor armature plate to 0.01” using a

feeler gauge. (See Figure 9)

Figure 9 – Mechanical Latch Mechanism Adjustment

(as viewed from the front with contactor

resting on the left side)

3. Tighten the three mechanism retaining bolts from under the

contactor.

A T T E N T I O NA T T E N T I O N

The return springs exert a significant force on the

armature plate. To avoid injury, do not place fingers

between the armature plate and the stop bracket at

any time.

4. Place the contactor upright and remove the C-Clamp. The

contactor should remain latched. Discharge the contactor by

unlatching it using the manual override.

5. Wire tie loose wires out of the way of moving components.

(See Figure 10)

1 2 ... 6 7 8 9 10 11 12 13 14

Brak uwag

Rockwell-automation 1502 Electrically-Held to Mechanically Latched Con Instrukcja Użytkownika Strona 11