Rockwell-automation 1769-ADN DeviceNet Modules Installation Instructio Instrukcja Użytkownika Pobierz pdf (Strona 17)

Rockwell Automation Publication DNET-IN001B-EN-P - January 2012 17

Install a 1756 DeviceNet Communication Module Chapter 1

Connect the Module to a

DeviceNet Network

Use an open-style 5- or 10-position linear plug to connect to the DeviceNet

network. An open-style 10-position linear plug is provided with your module.

Wire the connector according to the following illustrations.

Attach the connector to the module’s DeviceNet port as shown below. Tighten

the screws on the connector as needed.

IMPORTANT

For detailed DeviceNet connection information, see the DeviceNet Media

Design and Installation Guide, publication DNET-UM072

Also see the Industrial Automation Wiring and Grounding Guidelines,

publication 1770-4.1

WARNING: If you connect or disconnect the DeviceNet connector with

power applied to this module or any device on the network, an electrical

arc can occur. This could cause an explosion in hazardous location

installations.

Be sure that power is removed or the area is nonhazardous before

proceeding.

Red Dot

Black Dot

Blue Dot

White Dot

10-position Plug 5-position Plug

Linear Plug

10-position

Drop Line or

DeviceNet

Trunk Cable

Red

White

Bare

Blue

Black

10-position Linear Plug

DeviceNet Port

DeviceNet Drop Line

or Trunk Connector

USB Port

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 67 68

Brak uwag

Rockwell-automation 1769-ADN DeviceNet Modules Installation Instructio Instrukcja Użytkownika Strona 17