Rockwell-automation 20P PowerFlex DC Drive - Frame D In-Rush Limiting Instrukcja Użytkownika Pobierz pdf (Strona 2)

Publication 20P-IN065A-EN-P

To install the in-rush resistor:

❐ Step 1: Remove power from the drive

❐ Step 2: Open the control panel

❐ Step 3: Remove the existing in-rush resistor

❐ Step 4: Install the new in-rush resistor

❐ Step 5: Close the control panel and document the change

Step 1: Remove Power

from the Drive

1. Remove and lock-out all incoming power to the drive.

Step 2: Open the Control

Panel

1. Disconnect the DPI cable from the HIM (if present).

2. Insert a flathead screwdriver into the holes in the right side of the protective

covers on the drive and turn the latch 90° counter-clockwise.

3. Open the control panel to the left.

ATTENTION: Remove power before making or breaking cable

connections. When you remove or insert a cable connector with

power applied, an electrical arc may occur. An electrical arc can

cause personal injury or property damage by:

• sending an erroneous signal to your system’s field devices,

causing unintended machine motion

• causing an explosion in a hazardous environment

Electrical arcing causes excessive wear to contacts on both the

module and its mating connector. Worn contacts may create electrical

resistance.

L1 L2 L3

90°

Remove DPI

cable

1 2 3 4

Brak uwag

Rockwell-automation 20P PowerFlex DC Drive - Frame D In-Rush Limiting Instrukcja Użytkownika Strona 2