Rockwell-automation 20P PowerFlex DC Drive - Frame D Switching Power S Instrukcja Użytkownika Pobierz pdf (Strona 2)

Publication 20P-IN067A-EN-P

1. Remove and lock-out all incoming power to the drive.

2. Loosen, but do not remove, the four hexalobular screws that secure the top

control pan cover to the drive, then slide the cover up and off the drive

chassis (see Figure 1

below). Tightening torque is noted in the illustration

for reassembly.

3. Disconnect the DPI cable from the HIM assembly (if present) (see Figure 1

below).

Important:A communication cable connects the HIM assembly to the

Control board mounted on the control pan. Therefore, the

bottom control pan cover and HIM assembly cannot be fully

removed from the drive until the cable is disconnected. Step 4

details this connection.

4. Loosen, but do not remove, the four hexalobular screws that secure the

bottom control pan cover to the drive, then slide the cover up and off the

drive chassis (see Figure 1

below). Tightening torque is noted in the

illustration for reassembly.

Figure 1 Cover Removal

L1 L2 L3

Disconnect

DPI cable

Top control

pan cover

Bottom control

pan cover

Tightening torque:

1.5 N•m (13 lb•in)

T15

1 2 3 4

Brak uwag

Rockwell-automation 20P PowerFlex DC Drive - Frame D Switching Power S Instrukcja Użytkownika Strona 2