Rockwell-automation 2711 PanelBuilder Software Getting Started Instrukcja Użytkownika Pobierz pdf (Strona 94)

 

Publication 2711-6.2

Running the Application

This chapter shows how to run the application in the PanelView 900

terminal. It contains these sections.

Sections Page

Running the Motor in Auto Mode 8–1

Running the Motor in Manual Mode 8–3

This section shows how to monitor the motor in auto mode. In auto

mode, the motor is controlled by the SLC or PLC and continually

changes speed. All keys that are pressed in the procedure that

follows are located on the PanelView terminal.

After the application is downloaded, the PanelView terminal displays

the Motor Status screen.

The Motor Status indicators show that the motor is started and in

Auto mode.

To monitor the status of the motor in auto mode:

1. Press the

key to stop the motor.

Or if the terminal has a touch screen, press

Notice how the Start and Stop motor push buttons change

appearance to show the change in state.

The Status indicator in the Motor Status box also shows the

current status of the motor.

Chapter Objectives

Running the Motor

in Auto Mode

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 109 110

Brak uwag

Rockwell-automation 2711 PanelBuilder Software Getting Started Instrukcja Użytkownika Strona 94