Rockwell-automation 1402-LSM Line Synchronization Module Installation Instrukcja Użytkownika Pobierz pdf (Strona 32)

Chapter 3

General Operation

3–10

Discrete Outputs (From the PLC Processor)

The following discrete output control signals will be provided from the

PLC–5 processor via the back plane:

• Initiate Synchronization

• Auto–Synchronization Mode

• Check Synchronization Mode

• Permissive Synchronization Mode

• Load Share Disable

• Isochronous/Droop Mode

• Enable Single Phase Synchronization

Discrete Inputs (To the PLC Processor)

The following discrete input control signals will be provided to the PLC–5

processor via the back plane:

• Module Status

• Raise Voltage

• Lower Voltage

• Raise Speed –– frequency adjust

• Lower Speed –– frequency adjust

• Raise Speed –– phase adjust

• Lower Speed –– phase adjust

• Raise Power –– load share adjust

• Reduce Power –– load share adjust

• Close Breaker

• Synchronization Failure

• Power–up Bit

Block Transfer Data Interface

The LSM is capable of exchanging large amounts of data with the PLC

processor via the Block Transfer mechanism. The amount of data greatly

exceeds that which could be accommodated by a single block transfer. As a

result, the data is divided into several different “files” and can be obtained

through the use of multiple Block Transfers. The sizes, structure, and

contents of the block transfer reads and writes supported by the LSM are

provided in Appendix B. See “Block Transfer Communications”, listed on

Page 4–2 in the Application Information chapter of this manual for further

details on using Block Transfers.

PLC Interface Continued

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 86 87

Brak uwag

Rockwell-automation 1402-LSM Line Synchronization Module Installation Instrukcja Użytkownika Strona 32