Rockwell-automation 1734-VHSC24 Very High-Speed Counter Modules User M Instrukcja Użytkownika Pobierz pdf (Strona 43)

1 Publication 1734-UM003B-EN-P - August 2005

Chapter

Configure Your Module

What This Chapter Contains

This chapter describes how to configure your Very High-Speed

Counter modules with RSNetWorx.

Configuration Overview

Use RSNetWorx for DeviceNet software to configure your module.

You can configure the module while it is online or offline.

This chapter shows configuration in the online mode. Configuration

dialogs appear similar in both modes. The primary difference is that if

you make changes offline, you must go online before the

configuration changes take effect.

Add the Adapter to Your Network

Follow these steps to add an adapter to your network.

1. Start the RSNetWorx for DeviceNet software.

2. Add the communication device as shown in the figure, where

we chose a 1770-KFD RS232 Interface.

For More Information About See Page

Configuration Overview 4-1

Add the Adapter to Your Network 4-1

Add I/O Modules to Your Network 4-2

Set the Counter’s Parameters 4-5

Check I/O Status and View the EDS File 4-9

IMPORTANT

The scanner must always exist on the DeviceNet

network at Node 00.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 73 74

Brak uwag

Rockwell-automation 1734-VHSC24 Very High-Speed Counter Modules User M Instrukcja Użytkownika Strona 43