Rockwell-automation 1738-AENT ArmorPoint EtherNet/IP Adapter, Series A Instrukcja Użytkownika Pobierz pdf (Strona 7)

Publication 1738-IN017B-EN-E - March 2005

ArmorPoint EtherNet/IP Adapter, Series A 7

5. Mount the terminating base that was shipped with the adapter as

the last base in the backplane instead of the base that was

shipped with the I/O module.

Set the Network Address

The adapter ships with the rotary switches set to 999 and DHCP

enabled. To change the network address, you can:

• adjust the switches on the front of the module

• use a Dynamic Host Configuration Protocol (DHCP) server, such

as Rockwell Automation BootP/DHCP

• retrieve the IP address from nonvolatile memory

The adapter reads the switches first to determine if the switches are

set to a valid number. You set the network address by adjusting the 3

switches on the front of the module (refer to the illustration on page

1). Use a small blade screwdriver to rotate the switches. Line up the

small notch on the switch with the number setting you wish to use.

Valid settings range from 001 through 254.

Terminating base

43787

Mounting hole

Latching mechanism

Ground connection

This example

shows the

network address

set at 163.

43841

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Brak uwag

Rockwell-automation 1738-AENT ArmorPoint EtherNet/IP Adapter, Series A Instrukcja Użytkownika Strona 7