Rockwell-automation 1771-IFE ANALOG INPUT MODULE Instrukcja Użytkownika Pobierz pdf (Strona 15)

2–3Installing the Input Module

 "  ! 

Place your module in any I/O module slot of the I/O chassis except

for the extreme left slot. This slot is reserved for PC processors or

adapter modules.

Group your modules to minimize adverse affects from radiated

electrical noise and heat. We recommend the following.

• Group analog input and low voltage dc modules away from ac

modules or high voltage dc modules to minimize electrical noise

interference.

• Do not place this module in the same I/O group with a discrete

high-density I/O module when using 2-slot addressing. This

module uses a byte in both the input and output image tables for

block transfer.

The analog input module (1771-IFE/C) has configuration plugs for

determining the input type (voltage or current) desired for each

input. The module comes from the factory with the configuration

plugs positioned for voltage mode.

Note that you can select either voltage or current for each input, but

they must all be either single-ended or all differential.

Important: Do not mix single-ended and differential inputs on

the module.

To set the configuration plugs for your desired inputs:

        

      



Locating the Module in the

I/O Chassis

Setting the Configuration

Plugs on the Module

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 81 82

Brak uwag

Rockwell-automation 1771-IFE ANALOG INPUT MODULE Instrukcja Użytkownika Strona 15