Rockwell-automation 1771-IFE ANALOG INPUT MODULE Instrukcja Użytkownika Pobierz pdf (Strona 66)

C–3Programming Examples

-$('%#,'*) /  &$+-#+. 

1. Press [SHIFT][MODE] to display your ladder diagram on the

industrial terminal.

2. Press DD, 03:0[ENTER] to display the block transfer write file.

The industrial terminal screen should look like Figure C.2. Notice

the highlighted block of zeroes. This highlighted block is the cursor.

It should be in the same place as it appears in Figure C.2. If it is not,

you can move it to the desired position with the cursor control keys.

Once you have the highlighted cursor in the right place as shown

above, you can go on

to step 3.

Figure C.2 Write Block Transfer for a PLCĆ3 Processor



 



 













 /   

   / ! "

             !    

 

3. Enter the data corresponding to your bit selection in word 0

through 4.

4. When you have entered your data, press [ENTER]. If you make a

mistake, make sure the cursor is over the word you desire to

change. Enter the correct data and press [ENTER].

5. Press [CANCEL COMMAND]. This returns you to the ladder

diagram.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 81 82

Brak uwag

Rockwell-automation 1771-IFE ANALOG INPUT MODULE Instrukcja Użytkownika Strona 66