Rockwell-automation 2705 RediSTATION Operator Interface User Manual Instrukcja Użytkownika Pobierz pdf (Strona 41)

Publication 2705-UM001A-EN-P

Building a Custom RediSTATION 5-5

3. Mount the circuit board to the back of the 800T devices with the

DeviceNet terminal block oriented toward sealed connector/

conduit hole of enclosure. Use the two screws and plastic

spacers provided (2 sizes provided for different 800T device

depths). Tighten circuit board mounting screws to 14 in-lbs.

4. If you are not using a prewired DeviceNet connector, pull the

DeviceNet cable through the conduit at the top of the enclosure.

Then attach the 6 DeviceNet cable leads to the removable

terminal block connector.

Page 1-7 provides a description of the DeviceNet connections.

SpacersSpacers

Circuit Board Circuit Board

Mounting Screws

Toward sealed connector/

conduit hole of enclosure

ATTENTION

Do not connect the DeviceNet network to the

DeviceNet terminal block connector when power

is applied to the network or you may damage

the circuit board or the DeviceNet network.

ATTENTION

Use conduit fittings with proper seals on the

DeviceNet cable to maintain a watertight

enclosure.

Removable Terminal

Block Connector

Pin 1

Pin 6

Common

CAN Low

Shield

CAN High

VDC+

E GND

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

Brak uwag

Rockwell-automation 2705 RediSTATION Operator Interface User Manual Instrukcja Użytkownika Strona 41