Rockwell-automation 281E ArmorStart EtherNet/IP - Getting Started Instrukcja Użytkownika Pobierz pdf (Strona 30)

30 ArmorStart EtherNet/IP Distributed Motor Controller Getting Started

Publication 280E-QS001B-EN-P – February 2011

Bulletin 284E

Troubleshooting

Fault Definitions

Some of the Bulletin 284E ArmorStart Distributed Motor Controller faults are

detected by the internal hardware of the ArmorStart, while others are detected by

the internal drive. For internal drive faults, the internal hardware of the

ArmorStart simply polls the drive for the existence of faults and reports the fault

state. No fault latching is done by the internal hardware of the ArmorStart for

these faults. The PrFlt ResetMode parameter (Parameter 23) determines the

Auto Resettability of only the faults that are detected on the main control board.

The Auto Resettability of the faults that are detected in the internal drive is

controlled by internal drive parameters, refer to Table 9. The following flowchart

for Bulletin 284E units, is provided to aid in quick troubleshooting.

Figure 38 - Bulletin 284E Control Module LED Status

Faulted Display

See

Table 9

Fault

LED

Network

LED

Ye s

See

Table 6

See

Table 12

Actions

Motor will

not start

Define Nature

of the

Problem

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Brak uwag

Rockwell-automation 281E ArmorStart EtherNet/IP - Getting Started Instrukcja Użytkownika Strona 30