Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8 Instrukcja Użytkownika Pobierz pdf (Strona 122)

7Ć10 AutoMax Programming Executive Version 3.x

7.5 Configuring I/O for a Foreign Module

Foreign modules are added to the rack as generic modules (GEN32,

GEN32K or GEN32KH). To configure I/O for a generic module, select

the

described in section

7.4. Make certain that the foreign module meets the requirements in

Appendix H.

7.6 Modifying Variable Names and

Descriptions

Use the following procedure to modify variable names or

descriptions.

Step 1. Select the register/bit that you want to change.

Step 2. Backspace over the existing text and enter the new text.

Step 3. Select

another register/bit or

press ENTER. The new name

and/or description will be displayed.

Step 4. When you are finished changing variable names, you can

select Accept from the Variables menu to add the new

names/ descriptions to the database. Otherwise, when

you leave the V

ariable Configurator, you will be prompted

to save the changes.

7.7 Variables Menu

The

ariables menu consists of commands that enable you to copy,

delete, or modify variable names. You can also choose to have the

Executive software assign variable names to selected I/O points.

7.7.1 Cutting/Copying and Pasting V

ariable Names and

Descriptions

The names and descriptions of existing variables can be copied into

the W

indows Clipboard and then can be assigned to other registers

or bits of the same type, i.e., integer to integer and boolean to

boolean. You can cut/copy and paste variables to other registers or

bits on the same module or to another module. Network register

names can be pasted only into the network module form. The

contents of the Clipboard will remain until replaced by new data the

next time the Cut or Copy command is executed or until you leave

Windows.

Variable names and descriptions can be pasted to other variables in

three ways. If a single variable name and description are copied to

the Clipboard, they can be pasted to either (1) another single

destination or (2) to multiple destinations by selecting multiple

registers. If multiple variable names and descriptions are copied to

the Clipboard, they can (3) be copied only to a single destination

which acts as the starting point for the paste. The contents of the

Clipboard can be pasted as many times as required.

Note that when a register is copied, the bits assigned to that register

are not copied. The bits for the register must be copied and pasted

as a separate operation.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 297 298

Komentarze do niniejszej Instrukcji

Brak uwag

Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8 Instrukcja Użytkownika Strona 122

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Rockwell-automation 57C620 AutoMax Programming Executive Version 3.8