Rockwell-automation 6000 PowerFlex Medium Voltage Variable Frequency D Instrukcja Użytkownika Pobierz pdf (Strona 17)

Rockwell Automation Publication 6000-IN006A-EN-P - April 2014 17

Shipping and Handling Procedures Chapter 1

Figure 4 - Channel Steel Base Location

Bolt or weld the drive cabinet on the profile steel base (Refer to Affix Cabinets to

Floor on page 31). A reliable connection must be made between the steel base

and the cabinet. The steel base profile shall be reliably grounded.

Moving with Rod or Pipe Rollers

This method is only suitable when there are no inclines and the drive is moved on

the same floor.

Boards with cross section of about 50 ×150 mm (2 × 6 in.) and length of at least

300 mm (12 in.) longer than the drive must be placed under the wooden skid.

Lift the cabinet and carefully and slowly lower the drive cabinet onto the roller

pipes until the drive weight is borne on the roller pipes. Do not remove the

shipping skid; the skid is required for this process (see Attach the Overhead

Lifting Cables on page 20).

Roll the drive to its destination location. Steady the cabinet to prevent tipping.

Channel Steel Base

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 97 98

Brak uwag

Rockwell-automation 6000 PowerFlex Medium Voltage Variable Frequency D Instrukcja Użytkownika Strona 17