Rockwell-automation 6180P-xxxx Integrated Display Computers with Keypa Instrukcja Użytkownika Pobierz pdf (Strona 41)

Rockwell Automation Publication 6180P-UM001C-EN-P - February 2014 41

Component Replacement Chapter 4

Install an Add-in Card

The motherboard of the computers supports the following PCI slots.

• Two full-leng th P CI slots

• One half-length PCI slot

• One full-length ISA slot

Follow these steps to install an add-in card.

1. Follow the steps for Pre-configuration

on page 35.

2. Remove the computer cover as detailed in Remove the Cover

on page 36.

3. Remove the four screws

securing the chassis center

support bar (A) and detach

from the chassis (B).

4. Remove the four screws

securing expansion hold-down

bar (C) and detach from the

chassis (D).

5. Locate an empty PCI slot.

ATTENTION: Add-in cards are sensitive to ESD and require careful handling.

• Hold cards only by the edges.

• Do not touch the card connectors, components, or circuits.

• After removing an add-in card, place it on a flat, static-free surface, component

side up.

• Do not slide the card over any surface.

IMPORTANT

Use an antistatic wrist strap connected to the work surface, and properly

grounded tools and equipment.

D

C

B

A

C

A

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 67 68

Komentarze do niniejszej Instrukcji

Brak uwag