Rockwell-automation 6723-PCO DATA PROCESS CONFIG OPERATIO Instrukcja Użytkownika Pobierz pdf (Strona 3)

Quick Start

Publication

672310.1  August 1996

Process Configuration and

Operation Software for

Windowst

(Catalog Number 6723-PCO)

This Quick Start introduces experienced PLC-5 processor users,

6200 software users, and new Process Configuration and Operation

software users to installing and using PCO software.

Note: You can also use AI software. However, for the purposes of

this Quick Start, we will be using 6200 software.

This document shows you how to set up a system using a typical

configuration. For the purposes of this Quick Start, we will use the

application example of a forced-air grain-drying system to illustrate

the procedures you will use to develop a process control system with

PCO software.

This application example will show you how to:

• understand and define your process so that you can determine

your control requirements

• develop PLC code for use with PCO

• create Jump-to-Subroutine (JSR) instructions and Data Table files

• configure your process functions and load the appropriate

information about these configurations into your PLC processor

This Quick Start includes:

• basic information needed to start using the PCO application

quickly and effectively; we do not cover all PCO features

• high-level procedures with cross-references to other publications

for more detail

Refer to the Process Configuration and Operation Software User

Manual (publication 6723-6.5.1) for more specific information on

PCO functions and features.

Introduction

1 2 3 4 5 6 7 8 ... 35 36

Brak uwag

Rockwell-automation 6723-PCO DATA PROCESS CONFIG OPERATIO Instrukcja Użytkownika Strona 3