Rockwell-automation 1771-IFE/C INSTL.INSTRUCTIONS ANALOG INPU Instrukcja Użytkownika

Publication 17715.45 - July 1997Analog Input Module(Catalog Number 1771-IFE/C)Use this document as a guide when installing the 1771-IFE/C analoginput

Analog Input Module10Publication 17715.45 - July 1997Because of the many analog devices available and the wide varietyof possible applications, you

Analog Input Module 11Publication 17715.45 - July 1997Use the following table to read data from your input module.Dec. Bits 15 14 13 12 11 10 09 08

Analog Input Module12Publication 17715.45 - July 1997Default ConfigurationIf a write block of five words with all zeroes is sent to the module,defau

Analog Input Module 13Publication 17715.45 - July 1997Possible module fault causes and corrective action is described in thefollowing table.Indicato

Analog Input Module14Publication 17715.45 - July 1997ValueDescriptionThermal Dissipation 8.52 BTU/hr (maximum)Unscaled BCD and binary output toproce

Analog Input Module 15Publication 17715.45 - July 1997CSA Hazardous Location Approval Approbation d'utilisation dans des emplacements dangereux

Analog Input Module16Publication 17715.45 - July 1997Feature Series A, and B Series CIndicator lights 1. At power-up, the green run indicatorcomes o

Analog Input Module2Publication 17715.45 - July 1997If this product has the CE mark it is approved for installation withinthe European Union and EEA

Analog Input Module 3Publication 17715.45 - July 1997The module receives its power through the 1771 I/O power supplyand requires 500mA from the back

Analog Input Module4Publication 17715.45 - July 1997The module has configuration jumpers for determining the input type(voltage or current) desired

Analog Input Module 5Publication 17715.45 - July 1997!ATTENTION: Remove power from the 1771 I/Ochassis backplane and field wiring arm beforeremovi

Analog Input Module6Publication 17715.45 - July 1997Connect your I/O devices to the cat. no. 1771-WG wiring armshipped with the module.!ATTENTION:

Analog Input Module 7Publication 17715.45 - July 1997- Jumper all unused channels to modulecommon to reduce noise.Source GroundChannel 1Channel 2Cha

Analog Input Module8Publication 17715.45 - July 1997Source Ground- Unused channels must have their + and inputs jumpered together and tied tomodule

Analog Input Module 9Publication 17715.45 - July 1997Ground the Chassis and ModuleUse the following diagrams to ground yourI/O chassis and analog in