Rockwell-automation 1771-IFE/C INSTL.INSTRUCTIONS ANALOG INPU Instrukcja Użytkownika Pobierz pdf (Strona 4)

Analog Input Module4

Publication

17715.45 - July 1997

The module has configuration jumpers for determining the input type

(voltage or current) desired for each input. The module is shipped

with the configuration jumpers positioned for voltage mode and

the A/B simulation jumper set for Series C. If you are replacing a

Series A or B 1771-IFE module with this module, reset the

simulation jumper as shown above.

You can select either voltage or current for each input, but all inputs

must be either single-ended or differential. Do not mix single-ended

and differential inputs on the module.

Reposition the configuration jumpers associated with each input

channel according to your requirements

You can mix voltage mode and current mode settings on

the module. Make sure that the entire module is set for

either singleended or differential. Do not mix them.

Channel 1

Channel 2

Channel 3

Channel 4

Channel 5

Channel 6

Channel 7

Channel 8

Channel

1 and 2

Channel

3 and 4

Channel

5 and 6

Channel

7 and 8

Channel

9 and 10

Channel

1 and 12

Channel

13 and 14

Channel

15 and 16

DifferentialSingleended

Voltage Mode

Differential

Current

Singleended

Current

Differential or Singleended (factory set)

Current Mode

Odd channel current

Even channel voltage

Even channel current

Odd channel voltage

Singleended

Configuration

Jumpers

Remove the four screws securing the side cover to

the module and remove the covers.

19805

Reposition the cover and secure with the four

screws removed in step 1.

19813

Position the keying bands in the backplane connectors

to correspond to the key slots on the module.

Place the keying bands:

between 10 and 12

between 24 and 26

You can change the position of these bands if

subsequent system design and rewiring makes

insertion of a different type of module necessary.

Upper Connector

11022I

I/O chassis

Place your module in any slot in the chassis

except the leftmost slot which is reserved for

processors or adapters.

Key the Backplane Connector

Set the Configuration

Jumpers and Key the

Backplane Connector

1 2 3 4 5 6 7 8 9 ... 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Rockwell-automation 1771-IFE/C INSTL.INSTRUCTIONS ANALOG INPU Instrukcja Użytkownika Strona 4

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Rockwell-automation 1771-IFE/C INSTL.INSTRUCTIONS ANALOG INPU