Rockwell-automation 1794-ID2 U.MNL INCREMENTAL ENCODER Instrukcja Użytkownika Pobierz pdf (Strona 28)

2–6 How to Install Your Incremental Encoder Module

-%$,$(' 0  / 

5. Repeat the above steps to install the next terminal base.

Panel/Wall Mounting

Installation on a wall or panel consists of:

• laying out the drilling points on the wall or panel

• drilling the pilot holes for the mounting screws

• mounting the adapter mounting plate

• installing the terminal base units and securing them to the wall or

panel

If you are installing your module into a terminal base unit that is

already installed, proceed to “Mounting the incremental encoder

Module on the Terminal Base” on page2–7.

Use the mounting kit Cat. No. 1794-NM1 for panel/wall mounting.







1794ĆNM1 Mounting Kit

(', ',+

  (-',$'" %, !(* ), *

    + %!0,))$'" +* .+

 !(* ,# ), * ' 

# !(* -) ,(  &(-% +



), * (-%

'(, $'%- 

 *&$'% + '$,

'(, $'%- 

To install the mounting plate on a wall or panel:

1. Lay out the required points on the wall/panel as shown in the

drilling dimension drawing.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 87 88

Brak uwag

Rockwell-automation 1794-ID2 U.MNL INCREMENTAL ENCODER Instrukcja Użytkownika Strona 28