Rockwell-automation 2098 CompactLogix Indexing Motion Accelerator Tool Instrukcja Użytkownika Pobierz pdf (Strona 90)

90 Publication IASIMP-QS011B-EN-P — January 2009

Chapter 7 Motion System Application Guide

2. Press Start.

3. Check for power to drives, verify that you have provided a Drive Enable input to each of the

drives and try the Start command again. Refer to the Troubleshooting section on page 115 for

additional assistance.

4. Press Start again.

Stop State Actions

To stop your motion system, press Stop.

The state moves (green) from Running to Stopping and then to Stop.

Adjust the Speed

Follow these steps to adjust the relative speed of your motion system.

1. Press Speed.

The numeric keypad opens.

2. Enter a new speed value from the keypad.

3. Press the Enter button.

The keypad closes and motor speed is updated with

the new value.

If System Status Then

The (green) Stopped state moves to Resetting and

then to Aborted

The system failed to reset. Go to step 3.

The (green) Stopped state moves to Resetting and

then to Idle

Your system is ready to start. Go to step 4.

ATTENTION

The Start and Stop buttons on your PanelView Plus terminal display do not replace a hardwired

start/stop control circuit for safety purposes. Your motion system should also have an emergency

start/stop control circuit.

Enter

button

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 135 136

Brak uwag

Rockwell-automation 2098 CompactLogix Indexing Motion Accelerator Tool Instrukcja Użytkownika Strona 90