Rockwell-automation 5730 DriveLogix5730 Controller for PowerFlex 700S Instrukcja Użytkownika Pobierz pdf (Strona 95)

Communicating with Devices on a Serial Link 5-3

Configuring the Serial Port of the Controller

Characteristic: Description (default is shown in bold):

Mode Select System (for DF1 communication) or User mode (for ASCII communication).

Baud rate Specifies the communication rate for the serial port. Select a baud rate that all devices in your

system support.

Select 110, 300 600, 1200, 2400, 4800, 9600, 19200, or 38400 Kbps.

Parity Specifies the parity setting for the serial port. Parity provides additional message-packet error

detection.

Select None or Even.

Data bits Specifies the number of bits per message packet.

Select 8.

Stop bits Specifies the number of stop bits to the device with which the controller is communicating.

Select 1 or 2.

Control line Specifies the mode in which the serial driver operates.

Select No Handshake, Full-Duplex, Half-Duplex with Continuous Carrier, or Half-Duplex without

Continuous Carrier.

If you are not using a modem, select No Handshake

If both modems in a point-to-point link are full-duplex, select Full-Duplex for both controllers.

1. In the Controller Organizer, select the Controller folder. Right-click the

selected folder and select Properties.

2. On the Serial tab, specify serial port characteristics.

ahw0916.tif

ahw0915.tif

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 216 217

Brak uwag

Rockwell-automation 5730 DriveLogix5730 Controller for PowerFlex 700S Instrukcja Użytkownika Strona 95