Rockwell-automation 8520-OM Offline Development System User Manual Instrukcja Użytkownika Pobierz pdf (Strona 20)

2-- 6 Installing ODS

Publication 8520-- UM051A--EN--P -- July 2000

Offline DevelopmentManual (ODS) SoftwareUser Manual

16.Remove disk 1 from drive A.

Store the master ODS disks in a safe location. You can now print

the READ.ME file.

Using Windows NT

Important: This procedure assumes that drive A is a 3.5-inch

floppy-disk drive and that drive C is a hard-disk drive.

If the drive designations on your computer are different,

substitute the appropriate designations.

1. Turn on the computer and insert ODS disk 1 into drive A.

2. Click the Windows NT Start button and select Run. A similar

box appears:

If the correct path does not appear by default in the Open:

pulldown menu box, type the correct path (e.g., a:\install a: c:,

where a: is the source drive and c: is the destination drive).

3. Press

[ENTER]

The computer begins to execute the installation utility. Refer to

steps4through15intheUsing DOS section (beginning on

page 2--2) for further i nstructions on installing your ODS

software.

If you are using a DOS-based system, you can optimize ODS

performance, by modifying your CONFIG.SYS file.

Important: 8100 HS110 software does not require you to add the

line ‘DEVICE=DF1DRV.SYS’.

1. Modify the CONFIG.SYS file, if necessary, to include these lines:

BUFFERS=25

FILES=20

DEVICE=DF1DRV.SYS

Modifying the

CONFIG.SYS File

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 99 100

Brak uwag

Rockwell-automation 8520-OM Offline Development System User Manual Instrukcja Użytkownika Strona 20