Rockwell-automation 8520-OM Offline Development System User Manual Instrukcja Użytkownika Pobierz pdf (Strona 40)

4-- 4 Configuring ODS

Publication 8520-- UM051A--EN--P -- October 2000

Offline DevelopmentManual (ODS) SoftwareUser Manual

If your are using Windows NT, ODS allows you to select your

default printer from a list of printers t hat are currently available to

your system. Use the

[F5]--Configuration pulldown menu to access

Print device setup.

Use this procedure to select your print device:

1. Select the

Print device setup option from the

[F5]--Configuration menu. The following list box appears:

Select the appropriate baud rate for your serial communication

device. To abort this activity, select

<ESC>.

2. Select the appropriate print port for system. A checkmark

appears next to the current active choice. After you select a print

device, ODS saves it and makes this the default printer whenever

ODS is started. To cancel this selection, press

<ESC>.

ODS has a beeper that warns you when you press an illegal key or

when you attempt something that is not allowed. The

F5-Configuration menu l ets you decide whether or not to use the

beeper.

Use this procedure to set the beeper:

1. Select [

F5] and pull down the F5-Configuration menu.

You can set the beeper to ON or OFF. A checkmark appears next

to the current active choice. If this is the first time ODS has been

configured, the check is next t o

Beeper ON. After you make a

choice, ODS saves i t and puts the beeper in that state whenever

ODS is started.

2. Select either

Beeper ON or Beeper OFF.

The configuration m enu disappears, but the beeper i s s et

according to the choice you made.

Configuring Print Device

(Windows NT only)

Turning the Beeper

ON/OFF

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 99 100

Brak uwag

Rockwell-automation 8520-OM Offline Development System User Manual Instrukcja Użytkownika Strona 40