Rockwell-automation 8520-OM Offline Development System User Manual Instrukcja Użytkownika Pobierz pdf (Strona 86)

7-- 12 Using ODS Communication Configuration

Publication 8520-- UM051A--EN--P -- October 2000

Offline DevelopmentManual (ODS) SoftwareUser Manual

Refer to Figure 7.10 to see t he menu flow used to configure RSLinx

for Ethernet.

Figure 7.10

Configuration Flow for Using RSLinx for Ethernet (CNCs o nly)

RSLinx for Ethernet

RSLinx StationAddress

of 9/Series

AB_ETH

DriverNumber

Select the appropriate driver number for your configuration

This number corresponds to theAB_ETH driver configured in

RSLinx for Ethernet communication. The driver range is 01 to

64 (decimal). The default value is 01.

Select the station address that was mapped to the 9/Series control’s

IP address during RSLinx configuration. The address range is 0 to

63 (decimal). The default value is 0.

After you edit and save your AMP file, download it to t he 9/PC so

that it is the currently active AMP file. You can use ODS to

download AMP files three ways:

• from the local host PC i nto the 9/PC (refer t o page 5--3)

• from a separate network--connected ODS workstation that is

running Windows NT t o t he host PC and into the 9/PC card

• from an ODS workstation running Microsoft Windows NT and

Dial--up Networking, connected to the serial port of the host PC

running Microsoft’s’ Remote Access Services (RAS), and into the

9/PC card

In all cases, t he information you enter when creating the project is

used to direct the download to the correct 9/PC for this project. This

includes the host PC name and the topic name of the 9/PC card. This

project information can be changed at any time.

Configuring RSLinx for

Ethernet

Downloading AMP Files

for Use with the 9/PC

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 99 100

Brak uwag

Rockwell-automation 8520-OM Offline Development System User Manual Instrukcja Użytkownika Strona 86