
D-2 Spare Parts
1560E-UM050B-EN-P - June 2013
Table D.2
Bulletin 1503E, 1560E, 1562E • 2300 Volt, 180/360 Amp, 6-device Í
Qty per controller Description Part Number
180 A
6
Individual SCR, DCR820 or 5STP03D6500 (matching not required)
ÊË
80156-893-71-R
360 A
6
Individual SCR, DCR1020 or 5STP03D6500 (matching not required)
ÊË
80156-894-71-R
Common Components
Î
80165-898-52-R
3
SCR Gate Driver Board
(2 devices)
Ï
80165-898-55-R
1 IGDPS Board Ï 80026-044-02-R
1 Voltage Sensing Module 81000-199-55-R
1 MV SMC Interface Circuit Board 80190-440-01-R
9 Snubber Resistor 80025-588-02-R
3 Snubber Capacitor 0.68 µF, 4510 V peak 80025-812-02-R
3 Sharing Resistor, 32.5 k, 225 W, Two 2.5 k Tap 80025-753-01-R
2.5 m 80025-549-03-R
9 Fiber-optic Cable
5.0 m 80025-549-01-R
2 Bridge Rectifier { 24808-451-01-R
120 V 80145-581-02-R
2 MOV {
230 V 80145-581-07
120 V AC (North America) 80187-051-51-R
1 Test Power Supply
Universal 80187-245-51-R
110/120 V AC 80154-991-59-R
1
Contactor Relay Control
Panel {
220/230 V AC 80187-226-52
3 Power Fuses Ì Consult Engineering Data
2 CPT Primary Fuses Ì Consult Engineering Data
1 LV Fuses Consult Engineering Data
3 Heater Elements Ì Consult Engineering Data
2 20 Amp Contact Cartridge for Isolation Switch Auxiliary Ì 700-CPM
3 1-pole Blade Assembly (400 Amp) Ì 80145-566-51-R
Special Lubricant (for Blade Assembly, 400 Amp) 80158-357-51-R
Ê If desired, a complete factory assembled SCR/heatsink assembly can be purchased rather than individual SCRs.
See table below for part numbers :
Qty per controller Description Part Number
3 180 Amp, 2400 Volt Controller 80187-302-51
3 360 Amp, 2400 Volt Controller 80187-302-52
Ë Requires a thin film of electrical joint compound between base and mounting surface. Available with SCR replacement parts
or separately as Part Number 80025-783-51.
Ì 1562E only.
Í Reference only. 1503E – For OEM products, refer to OEM-supplied documentation for specific spare parts list.
1560/1562E are Allen-Bradley manufactured starters. Refer to Service Manual for specific spare parts list.
Î Used when options 13XG (Stop Contrtol) or 13XB (Pump Control) are not provided.
Ï Used when options 13XG (Stop Control) or 13XB (Pump Control) are provided.
{ Not provided if IntelliVAC control is used (refer to Publication 1503-UM051B-EN-P for spare part information on IntelliVAC).
Komentarze do niniejszej Instrukcji