Rockwell-automation MPMA Integrated Multi-Axis Linear Stages Instrukcja Użytkownika Pobierz pdf (Strona 63)

Rockwell Automation Publication MPMA-UM001B-EN-P - November 2010 63

Maintenance Chapter 7

5. Repeat step 3 and step 4 to the other lubrication ports.

6. Move the carriage to opposite end of travel and repeat steps 1

…5.

7. Remove the clamp.

8. Reinstall the protective caps on all the lubrication ports.

Clean the Strip Seal

Clean the strip seals, if installed, using a lint free cloth lightly saturated with

isopropyl alcohol.

Refer to the Remove the Strip Seal

on page 69 and Replace the Strip Seal on

page 71 when performing this task.

Clean the Cover

Clean the covers at the same time you clean the strip seals. Use pressurized air and

a lint free cloth lightly saturated with isopropyl alcohol to remove any dirt or

grease.

IMPORTANT

Replace the strip seal if it cannot be cleaned, or if an uneven or

scored surface is detected during cleaning.

A buildup of foreign material on the strip seal degrades the

performance of the linear stage. This buildup coupled with rapid

movement of the carrier and the resulting friction will score the

surface and create a burnished appearance on the strip seal.

Elements that contribute to a typical buildup on the strip seals are

dust, grease, and other contaminants normally encountered in any

operating environment that is not strictly controlled.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 135 136

Brak uwag

Rockwell-automation MPMA Integrated Multi-Axis Linear Stages Instrukcja Użytkownika Strona 63