Rockwell-automation SA3100 Distributed Power System Drv Config,Program Instrukcja Użytkownika Strona 127
- Strona / 162
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
SA3100 Local Tunable Variables
C-5
C.3 Volts per Hertz Voltage Point Gain Variables
The seven gains below represent the seven voltage points of the V/Hz characteristic
curve. When the PMI Regulator detects a set of 0 value volts per hertz characteristic
gains it will calculate a curve.
When the enable tuning command (register 100/1100, bit 1, PMI_TUN@) is asserted,
these gains are reset to their default values. When the reset is complete register 200,
bit 1 (PMI_ATC@) is set.
See Appendix E (Figures E.2 and E.3) for more information on the V/Hz characteristic.
P0VT_E3! Point 0 Voltage
This value is set to select the voltage at point 0
in the V/Hz characteristic curve.
This value is entered in times 1000, e.g., 50
volts is entered as 50000.
Units: Volts
∗
1000
Default Value: 0
Low Limit: 0
High Limit: 1000000
Step: 1
P1VT_E3! Point 1 Voltage
This value is set to select the voltage at point 1
in the V/Hz characteristic curve.
This value is entered in times 1000, e.g., 50
volts is entered as 50000.
Units: Volts
∗
1000
Default Value: 0
Low Limit: 0
High Limit: 1000000
Step: 1
P2VT_E3! Point 2 Voltage
This value is set to select the voltage at point 2
in the V/Hz characteristic curve.
This value is entered in times 1000, e.g., 50
volts is entered as 50000.
Units: Volts
∗
1000
Default Value: 0
Low Limit: 0
High Limit: 1000000
Step: 1
P3VT_E3! Point 3 Voltage
This value is set to select the voltage at point 3
in the V/Hz characteristic curve.
This value is entered in times 1000, e.g., 50
volts is entered as 50000.
Units: Volts
∗
1000
Default Value: 0
Low Limit: 0
High Limit: 1000000
Step: 1
P4VT_E3! Point 4 Voltage
This value is set to select the voltage at point 4
in the V/Hz characteristic curve.
This value is entered in times 1000, e.g., 50
volts is entered as 50000.
Units: Volts ∗ 1000
Default Value: 0
Low Limit: 0
High Limit: 1000000
Step: 1
- Distributed Power System 1
- CONTENTS 3
- List of Figures 5
- List of Tables 7
- CHAPTER 1 9
- Introduction 11
- CHAPTER 2 13
- Figure 2.2 – Adding Flex I/O 15
- Regulator 17
- • Part Number 18
- • Carrier Frequency 18
- 1 HP = 0.746 KW 21
- • Current (Amps) 22
- Frequency at Rated Voltage 23
- Rated Full Load Speed 23
- • Speed Feedback Type 24
- • Resolver Type (x1, x2, x5) 24
- • Resolution 24
- • Constant or Variable Torque 30
- • Unmodulated Six Step 30
- • Current Limit 31
- • Current Limit Delay 31
- • Full Load Amps (Amperes) 31
- • Voltage Boost Volts (Volts) 33
- 2.5 Configuring Flex I/O 36
- • Channel 0 to Channel 7 37
- CHAPTER 3 39
- Used in this Manual 41
- 3.2.1 Digital Data Formats 45
- 3.2.2 Analog Data Formats 46
- ⇓⇓⇓⇓⇓⇓⇓⇓⇓⇓⇓⇓ 46
- ⇓⇓⇓⇓⇓⇓⇓⇓⇓⇓⇓ 46
- (Registers 80-89/1080-1089) 49
- *Reserved for future use 59
- Reserved for future use 59
- Reserved for Future Use 60
- Figure 3.1 – UDC Task Scan 88
- Meter Port 1 95
- Meter Port 2 96
- Meter Port 3 97
- Meter Port 4 98
- 2000-2047) 99
- CHAPTER 4 103
- Figure 4.1 – UDC Task Scan 104
- 4.2.2 Local Tunable Variables 108
- CCLK_OK@ COM_FLT@ RUN_PERM@ 111
- RUN_PERM@ 111
- Permissive 111
- CHAPTER 5 113
- On-Line Operation 115
- APPENDIX A 117
- APPENDIX B 119
- APPENDIX C 123
- C.5 DC Bus Variables 130
- C.7 Diagnostic Variables 132
- APPENDIX D 133
- (ANGLE OF VECTOR) 134
- D.1 Dual Wound Motor 135
- APPENDIX E 137
- Frequency 140
- Output Volts 140
- APPENDIX F 141
- APPENDIX G 143
- APPENDIX H 145
- APPENDIX I 147
- APPENDIX J 148
- Reference Material 152
- ● stator time constant: 153
- ● stator resistor: 153
- ● magnetizing current: 153
- This Page Intentionally Blank 155
Powiązane produkty i podręczniki dla Ekwipunek Rockwell-automation SA3100 Distributed Power System Drv Config,Program
Ekwipunek Rockwell-automation T3151 ICS Regent Real time Clock Communications Mo Instrukcja Użytkownika
(14 strony)
(14 strony)
Ekwipunek Rockwell-automation 1606-XLP XM Electronic Overspeed Detection System Instrukcja Użytkownika
(72 strony)
(72 strony)
Ekwipunek Rockwell-automation 440F MatGuard, 440F-C4000 Mat Controllers Instrukcja Użytkownika
(44 strony)
(44 strony)
Ekwipunek Rockwell-automation T8296 Trusted Utilities Distribution Unit Instrukcja Użytkownika
(2 strony)
(2 strony)
Ekwipunek Rockwell-automation Safety Guidelines for the Application, Installatio Instrukcja Użytkownika
(28 strony)
(28 strony)
Ekwipunek Rockwell-automation 20Y PowerFlex 700H, 700S, and 700AFE Drive Fan Sys Instrukcja Użytkownika
(296 strony)
(296 strony)
Ekwipunek Rockwell-automation Logix5000 Control Systems: Connect ArmorBlock I/O Instrukcja Użytkownika
(30 strony)
(30 strony)
Ekwipunek Rockwell-automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Instrukcja Użytkownika
(249 strony)
(249 strony)
Ekwipunek Rockwell-automation T7488/T7488A ICS Regent+Plus Monitored Guarded Out Instrukcja Użytkownika
(26 strony)
(26 strony)
Ekwipunek Rockwell-automation MD60 Remote OIM Installation Instructions Instrukcja Użytkownika
(6 strony)
(6 strony)
Ekwipunek Rockwell-automation FlexPak 3000 Drive Field Current Regulator Kit, 91 Instrukcja Użytkownika
(42 strony)
(42 strony)
© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.025 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji