Rockwell-automation SA3100 Distributed Power System Drv Config,Program Instrukcja Użytkownika Pobierz pdf (Strona 73)

Configuring the UDC Module’s Registers

3-35

Drive Fault Register (Continued) 202/1202

Overspeed Fault Bit 10

The Overspeed Fault bit is set if the motor’s

velocity exceeds the value entered as the

Overspeed Trip (RPM) configuration

parameter.

Hex Value: 0400H

Sug. Var. Name: FLT_OSP@

Access: Read only

UDC Error Code: 1010

LED: EXT FLT

Power Technology Fault Bit 11

The Power Technology Fault bit is set to

indicate a problem with the AC power

technology circuit on the PMI Regulator

motherboard.

Hex Value: 0800H

Sug. Var. Name: FLT_PTM@

Access: Read only

UDC Error Code: 1011

LED: OK

Bit 12

Reserved for future use.

Hex Value: 1000H

Sug. Var. Name:

Access: Read only

UDC Error Code: 1012

LED:

PMI Regulator Bus Fault Bit 13

The PMI Regulator Bus Fault bit is set if the

Resolver & Drive I/O board or the AC power

technology circuit does not respond to

requests from the PMI Processor. This

indicates a hardware problem in the PMI

Regulator.

Hex Value: 2000H

Sug. Var. Name: FLT_BUS@

Access: Read only

UDC Error Code: 1013

LED: N/A

UDC Run Fault Bit 14

The UDC Run Fault bit is set if the UDC task

stops while the minor loop is running in the

PMI Regulator.

Hex Value: 4000H

Sug. Var. Name: FLT_RUN@

Access: Read only

UDC Error Code: 1014

LED: N/A

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 161 162

Komentarze do niniejszej Instrukcji

Brak uwag

Rockwell-automation SA3100 Distributed Power System Drv Config,Program Instrukcja Użytkownika Strona 73

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Rockwell-automation SA3100 Distributed Power System Drv Config,Program