Rockwell-automation SB3000 Configuration and Programming Instrukcja Użytkownika Pobierz pdf (Strona 53)

Configuring the UDC Module’s Registers

3-35

Power Device Status Register (Continued) 204/1204

Phase W-Lower IOC A Bit 5

The Phase W-Lower A status bit is set if an

IOC or DSAT fault occurs in Power Module

A’s phase W, lower power device.

Hex Value: 0020H

Sug. Var. Name: W_LOA@

Access: Read only

UDC Error Code: N/A

LED: N/A

Intelligent Power Module A Bit 6

The Intelligent Power Module A bit is set to

indicate that a DSAT (shoot-through) fault

has occurred in Power Module A. Bits 0 - 5

should be checked to identify the device in

which the fault occurred.

Hex Value: 0040H

Sug. Var. Name: IPMA@

Access: Read only

UDC Error Code: N/A

LED: N/A

GDI Fault A Bit 7

The GDI Fault A bit is set if a problem is

detected with the power supply of Power

Module A’s Gate Driver Interface module.

Hex Value: 0080H

Sug. Var. Name: GDIA@

Access: Read only

UDC Error Code: N/A

LED: N/A

Charge Fault Bit 8

The Charge Fault A bit is set if a charge bus

time-out fault occurs in Power Module A.

(refer also to register 202/1202, bit 6).

Hex Value: 0100H

Sug. Var. Name: CHGA@

Access: Read only

UDC Error Code: N/A

LED: N/A

Phase U Loss Bit 9

The Phase U Loss bit is set if AC line phase

U is lost.

Hex Value: 0200H

Sug. Var. Name: U_PL@

Access: Read only

UDC Error Code: N/A

LED: N/A

Phase V Loss Bit 10

The Phase V Loss bit is set if AC line phase

V is lost.

Hex Value: 0400H

Sug. Var. Name: V_PL@

Access: Read only

UDC Error Code: N/A

LED: N/A

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 121 122

Komentarze do niniejszej Instrukcji

Brak uwag

Rockwell-automation SB3000 Configuration and Programming Instrukcja Użytkownika Strona 53

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Rockwell-automation SB3000 Configuration and Programming