Rockwell-automation SB3000 Configuration and Programming Instrukcja Użytkownika Pobierz pdf (Strona 63)

Configuring the UDC Module’s Registers

3-45

Parallel Power Module C Status Register (Continued) 221/1221

GDI Fault C Bit 7

The GDI Fault C bit is set if a fault is

detected in the power supply of Power

Module C’s Gate Driver Interface module.

Hex Value: 0080H

Sug. Var. Name: GDIC@

Access: Read only

UDC Error Code: N/A

LED: N/A

Charge Fault C Bit 8

The Charge Fault C bit is set if a charge bus

time-out fault occurs in Power Module C

(refer also to register 202/1202, bit 6).

Hex Value: 0100H

Sug. Var. Name: CHGC@

Access: Read only

UDC Error Code: N/A

LED: N/A

Over Temperature C Bit 12

The Over Temperature C bit is set if an over

temperature fault or warning occurs in

Power Module C.

Hex Value: 1000H

Sug. Var. Name: OTC@

Access: Read only

UDC Error Code: N/A

LED: N/A

Phase U Current Sharing C Bit 13

The Phase U Current Sharing C bit is set if a

Power Module C is not carrying its share of

the phase U current.

Hex Value: 2000H

Sug. Var. Name: U_SHRC@

Access: Read only

UDC Error Code: N/A

LED: N/A

Phase V Current Sharing C Bit 14

The Phase V Current Sharing C bit is set if

Power Module C is not carrying its share of

the phase V current.

Hex Value: 4000H

Sug. Var. Name: V_SHRC@

Access: Read only

UDC Error Code: N/A

LED: N/A

Phase W Current Sharing C Bit 15

The Phase W Current Sharing C bit is set if

Power Module C is not carrying its share of

the phase W current.

Hex Value: 8000H

Sug. Var. Name: W_SHRC@

Access: Read only

UDC Error Code: N/A

LED: N/A

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 121 122

Komentarze do niniejszej Instrukcji

Brak uwag

Rockwell-automation SB3000 Configuration and Programming Instrukcja Użytkownika Strona 63

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Rockwell-automation SB3000 Configuration and Programming