Rockwell-automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATI Instrukcja Użytkownika Pobierz pdf (Strona 41)

Rockwell Automation Publication 1788-UM057B-EN-P - September 2014 39

Set Up in the Studio 5000 Logix Designer Application Chapter 2

Add a Connector

A connector enables transfer of data between the

block of the field device and the data structure in the

controller, or between field device blocks on the same

segment. Data transfers between segments are

performed via the controller.

Follow these steps to add a connector.

1. To add a connector, right-click in the window and choose New Connector.

2. Set the desired options in the Add Connector dialog box to configure the

connector, and click OK.

Tab le 5

describes the four types of connectors.

Table 5 - Connector Types

TIP

The configuration of input and output connectors requires the definition of the

data being transferred. See the user manual of the field device for data type,

length, offset, and number of status bytes. The default is the most common.

Connector Type Data Transfer Use Icon

Input : I.PV From a field device to the controller.

Output : O.PV From the controller to the field device.

Network Publication

From a field device to another field device on

the same segment.

Network Subscription

From another field device on the same

segment to the field device.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 103 104

Brak uwag

Rockwell-automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATI Instrukcja Użytkownika Strona 41