Rockwell-automation AutoMax ControlNet Communication Interface Module Instrukcja Użytkownika Pobierz pdf (Strona 74)

Page 74 AutoMax ControlNet Module

Publication number DSMBCN-UM001B-EN-P February 2003

2. When the AutoMax is powering up, the 7-segment LED flashes

some numbers, then displays ‘.b’ for 4 seconds. While it shows ‘.b’,

press the exclamation mark (!) key in your communication software

to tell the MBCN that you want to download firmware.

3. The 7-segment display changes to ‘A’ to tell you the MBCN is in

system configuration mode. The commands available are:

LoadFW to load a new firmware module into flash

LoadPGA to load a new PGA module into flash

Ver to display the current firmware version numbers

Run to exit System Configuration mode

Help to display available commands

To load a new firmware module:

1. Type

LoadFW, (or LoadSSF for versions before 1.10) and the MBCN

responds with the message

Start Your XMODEM Send, Ctrl-X to Cancel

2. Initiate an Xmodem send of the MBCN firmware file 423627-

5A.FW (formerly RECNET.SSF) using your communication

software.

3. When the download is complete, the MBCN asks if you want to

program the new firmware into flash. Enter ‘y’ to confirm.

4. When the firmware has been programmed into flash, use the Ver

command to confirm that the version number is correct.

5. Use the Run command to exit System Configuration mode and

resume normal operation. The MBCN resumes its normal startup

sequence and finally displays a ‘7’.

6. If you load a new firmware module, you should resend the I/O

configuration and set the network parameters and schedule.

To load a new PGA module:

1. Type

LoadPGA, (or LoadSSP for versions before 1.10) and the MBCN

responds with the message

Start Your XMODEM Send, Ctrl-X to Cancel

2. Initiate an Xmodem send of the MBCN firmware file 423627-

4A.PGA (formerlyCN_RELI.SSP) using your communication

software.

3. When the download is complete, the MBCN asks if you want to

program the new firmware into flash. Enter ‘y’ to confirm.

4. When the firmware has been programmed into flash, the MBCN

displays the message

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 80

Brak uwag

Rockwell-automation AutoMax ControlNet Communication Interface Module Instrukcja Użytkownika Strona 74