Rockwell-automation AutoMax ControlNet Communication Interface Module Instrukcja Użytkownika Pobierz pdf (Strona 9)

Introduction

This introduction covers the following topics:

• who should use this manual

• the purpose of the manual

• contents of the manual

• conventions used in the manual

• getting support

Who Should Use This Manual?

Use this manual if you are responsible for designing, installing,

programming or troubleshooting systems that are based on AutoMax

Control using the MBCN ControlNet module (O-58820-2) with major

revision 2 firmware.

You should have a basic understanding of AutoMax products. You

should understand Allen Bradley PLC-5s and ControlLogix PLCs and be

familiar with using ControlNet I/O modules on the ControlNet network.

Purpose of this Manual

This manual shows you how to install and use the MBCN ControlNet

module. It describes the procedures to install, configure, and operate the

MBCN ControlNet module.

Conventions Used in this Manual

The following conventions are used throughout this manual:

• bulleted lists, such as this one, provide information, not procedural

steps

• numbered lists provide sequential steps

• bold type is used for emphasis

•

courier font is used for text you should type

• hexadecimal numbers are shown with a trailing ‘h’, for example,

1234h

• titles for menu items, dialog boxes, etc. in software are shown in

italics

• addresses that refer to a single byte within an AutoMax register are

shown with a trailing ‘L’ or ‘H’ to indicate the low or high byte of

the register.

• T=>O means ControlNet target-to-originator; O=>T means

originator-to-target. The originator is the node that opens the

connection to the target.

• RSNetWorx means RSNetWorx for ControlNet

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 79 80

Brak uwag

Rockwell-automation AutoMax ControlNet Communication Interface Module Instrukcja Użytkownika Strona 9