Rockwell-automation 22-COMM-B PowerFlex BACnet MS/TP Adapter Instrukcja Użytkownika Pobierz pdf (Strona 17)

Chapter 2

Installing the Adapter

This chapter provides instructions for installing the adapter in a

PowerFlex 40 or PowerFlex 400 drive. This adapter can also be installed

in a DSI External Comms Kit. In this case, refer to the

22-XCOMM-DC-BASE Installation Instructions (publication

22COMM-IN001) supplied with the kit.

Before installing the adapter, verify that you have all required

equipment. Refer to Required Equipment

on page 1-3.

To commission the adapter, you must set a unique MAC address and,

depending on where the PowerFlex drive node is located on the network

(starting and ending network nodes versus all other node locations),

appropriately set the TERM, -BIAS, and +BIAS switches.

Important: New settings are recognized only when power is applied to

the adapter or it is reset. If you change a switch setting,

cycle power or reset the adapter to apply the change.

Topic Page

Preparing for an Installation

2-1

Commissioning the Adapter 2-1

Connecting the Adapter to the Drive 2-6

Applying Power 2-9

Connecting the Drive/Adapter to the Network 2-11

Preparing for an Installation

Commissioning the Adapter

ATTENTION: Risk of equipment damage exists. The adapter

contains ESD (Electrostatic Discharge) sensitive parts that can be

damaged if you do not follow ESD control procedures. Static control

precautions are required when handling the adapter. If you are

unfamiliar with static control procedures, refer to Guarding Against

Electrostatic Damage (publication 8000-4.5.2).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 71 72

Brak uwag

Rockwell-automation 22-COMM-B PowerFlex BACnet MS/TP Adapter Instrukcja Użytkownika Strona 17