Item Part Description
➊ Node Address
switches
Switches for setting the node address of the
adapter. See Setting the Endianness and
Node Address Using the DIP Switches on
page 14.
Endianness Selection
switch (Switch 8)
Sets the endianness of data transmitted over
network.See Setting the Endianness and
Node Address Using the DIP Switches on
page 14.
➋ Adapter-to-Drive
header
A 40-pin, double-row shrouded female
header. An interface connector is used to
connect this header to a header on the drive.
➌ Status indicators Three LEDs that indicate the status of the
connected drive, adapter and network. See
Troubleshooting
on page 69.
➍ CS1/CS2 terminals Provides a clean ground for the
communication bus cable shields.
CS1 or CS2 should be connected to a clean
ground or PE ground on the drive.
➎ PROFIBUS DB9
Female connector
PROFIBUS connector for the PROFIBUS
network cable.
25-COMM-P
➊
➋
➌
➍
➎
Komentarze do niniejszej Instrukcji