Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Instrukcja Użytkownika Strona 193

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 820
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 192
Running a Program
Chapter 7
7-5
Before selecting a part program , you must tell the control where this part
program is currently residing. You have 3 options:
the program can reside in the control’s memory
the program can reside on a peripheral device attached to port A such as
a tape reader (see your system installers documentation)
the program can reside on a peripheral device attached to port B such as
a tape reader (see your system installers documentation)
Important: If selecting a peripheral device attached to one of the two
communication ports (A or B), that port must have previously been
configured to communicate to that specific peripheral device. See chapter
9 for details on communications setup for ports A and B . Selecting a
program from the control’s memory is the default configuration of the
control. If port A or B is never selected, the input device should remain at
its default of control memory and the following procedure should be
unnecessary.
To select the part program input device:
1. Press the
{PRGRAM MANAGE} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
PRGRAM
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2. Press the {INPUT DEVICE} softkey.
REFORM
MEMORY
CHANGE
DIR
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
7.2
Selecting a Part Program
Input Device
Przeglądanie stron 192
1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 819 820

Komentarze do niniejszej Instrukcji

Brak uwag