Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Instrukcja Użytkownika Pobierz pdf (Strona 665)

100

101

Paramacros

Chapter 20

20-21

#3006

ProgramStop With Message

Use this parameter to cause a cycle stop operation and display a message

on line 1 of the CRT. It is a write-only parameter. Any block that assigns

a new value to parameter #3006 results in a cycle stop. Any value can be

assigned to this parameter. The actual value is not used.

ATTENTION: Once axis reciprocation begins, it continues

until stopped by a G80, or an end of program (M02, M30,

M99). This means executing paramacro #3006 in a part

program does not necessarily stop the reci procating axis.

When the control executes this block, a cycle stop is performed and the

message “SEE (MESSAGE) IN PART PROGRAM BLOCK” is displayed

on line 1 of the CRT. This is intended to point out to the operator that an

important comment is in a program block (see page 10-10 for det ails on

comment blocks).

For example, programming:

#3006=.1 (Install Wheel Number 6);

causes program execution to stop at the beginning of this block and the

message display to tell the operator to read the comment in the block.

1 2 ... 660 661 662 663 664 665 666 667 668 669 670 ... 819 820

Komentarze do niniejszej Instrukcji

Brak uwag

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Instrukcja Użytkownika Strona 665

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra